Kind of have riser blocks. I have some 3/4" scrap Baltic birch plywood, plus the included risers for the Foreman… but i also have shy of 1" mdf, and t-tracks for the table. I segmented my wasteboard so i can remove a section of my mdf and put the rotary on some 2020 AL. My plan isn’t perfect because the tail stock has some slop. I squared my headstock by marking a line on a 12" long piece of lumber and followed the spindle down and tightened it.
I also raised my spindle some. This is the spindle in full down
plywood riser I have
This is the cut out area i was speaking of
What the setup looks like, except when I’m doing a rotary job, I’ll take the above squares out.
Hashtag dominator has 8" clearance!!!