Masso g4 command
Some controllers/controller software don’t recognize the P as milliseconds, and ignore it reverting to full seconds.
Mine recognizes the p as milliseconds.
But that’s why we provide it in raw text, so that you can modify as necessary. It’s only a guide anyways, and just because it’s done, doesnt mean it’s ready, but then also just because it hasn’t finished yet doesnt mean it’s not ready either. Environmental considerations and time since last used are more important than the time.
I did a write up in the Facebook group when i was using my shapeoko, but i don’t know if it’s still there since I’m on a social media hiatus. I used g4p6000 for a 6 second delay instead of having it get up to speed while cutting or moving to a cut. I didn’t use carbide motion, and if you do, that software is really restrictive with what you can do.
It’s also been discussed here.