Here is an area for you to share your experiences, good and bad and offer advice if you’ve experienced a similar situation.
category rules:
-
If seeking advice, please don’t leave out any information. Things like voltage, spindle diameter, ER collet size, and air or water as well as controller. Frame size is irrelevant (Shapeoko 3 will perform the same as a Shapeoko 3 XL or XXL)
-
If discussing ATC, only ATC & 110v or 220v and controller is necessary.
-
Please describe what is (not) happening vs what you are expecting to happen and what steps you are conducting to complete the task. The more detail the better.
-
Please be aware we only know what is shared, so please share everything.