Has any one Ecperience this problem before?

General
1

ok first of all this my first time reaching out on the forum but i was wondering if anyone has experienced this problem with there spindle before?

I have i EM60 spindle. Every time i start running the program my spindle kicks one and starts running and when it starts cutting my spindle acts like it doesn’t have the strength to cut the wood, it literaly bogs down and stops. i have ran this program multiple times and never has a problem running it.

dose anyone have any experience with is problem?

thanks ahead Thompson

2

Em60 is the vfd.

Things like voltage, bit dimensions & sharpness, feed & speed and material lead to the problem your discussing.

You said you’ve run it several times before which seemingly eliminates feed & speed and bit dimensions, but not the sharpness of the bit and material. Assuming the material is the same or similar type, I could only guess try a new bit

1 Like