# Tool Changer Setup

**URL:** <https://forum.pwncnc.com/t/tool-changer-setup/2341>\
**Category:** General\
**Created:** [November 21, 2024, 12:35pm UTC](https://forum.pwncnc.com/t/tool-changer-setup/2341 "2024-11-21T12:35:18Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![markcthomassr](https://avatars.discourse-cdn.com/v4/letter/m/6f9a4e/32.png) [@markcthomassr](https://forum.pwncnc.com/u/markcthomassr)\
**Post date:** [November 21, 2024, 12:35pm UTC](https://forum.pwncnc.com/t/tool-changer-setup/2341/1 "2024-11-21T12:35:18Z")

</div>

I have 7 tools lined up on the left side of my table. Can I also line more up on the right side?

---

<div class="post-metadata">

**Author:** ![Wood](https://avatars.discourse-cdn.com/v4/letter/w/7993a0/32.png) [@Wood](https://forum.pwncnc.com/u/Wood)\
**Post date:** [November 21, 2024, 9:40pm UTC](https://forum.pwncnc.com/t/tool-changer-setup/2341/2 "2024-11-21T21:40:55Z")

</div>

You would have to program the tool holder coordinates into the MASSO regardless of where the tool holder is the machine would go to the programmed coordinates for that tool change operation. So yes you can

---

<div class="post-metadata">

**Author:** ![markcthomassr](https://avatars.discourse-cdn.com/v4/letter/m/6f9a4e/32.png) [@markcthomassr](https://forum.pwncnc.com/u/markcthomassr)\
**Post date:** [November 22, 2024, 12:16pm UTC](https://forum.pwncnc.com/t/tool-changer-setup/2341/3 "2024-11-22T12:16:19Z")

</div>

Thank you! I have lots of bits.

---

<div class="post-metadata">

**Author:** ![Wood](https://avatars.discourse-cdn.com/v4/letter/w/7993a0/32.png) [@Wood](https://forum.pwncnc.com/u/Wood)\
**Post date:** [November 23, 2024, 12:29am UTC](https://forum.pwncnc.com/t/tool-changer-setup/2341/4 "2024-11-23T00:29:31Z")

</div>

With the right dustboot and tool holder design in theory you have just over 20 tool holders on on side check out uglydog workshop on YouTube he has a great optimized setup