# Movable Tool Slide

**URL:** <https://forum.pwncnc.com/t/movable-tool-slide/989>\
**Category:** Unsanctioned Enhancements\
**Created:** [March 20, 2024, 5:52pm UTC](https://forum.pwncnc.com/t/movable-tool-slide/989 "2024-03-20T17:52:53Z")\
**Posts on this page:** 1\
**Showing post:** 16

<div class="post-metadata">

**Author:** ![Chris](https://yyz1.discourse-cdn.com/flex011/user_avatar/forum.pwncnc.com/chris/32/54_2.png) [@Chris](https://forum.pwncnc.com/u/Chris)\
**Post date:** [July 15, 2024, 4:56pm UTC](https://forum.pwncnc.com/t/movable-tool-slide/989/16 "2024-07-15T16:56:39Z")

</div>

I wrote about fork movements in the the [KB’s](https://support.pwncnc.com/kb/article/460-programming-of-atc-in-masso/)

 ![Screenshot 2024-07-15 095304](https://canada1.discourse-cdn.com/flex011/uploads/pwncnc/original/1X/73763a210881562848785cd5ef1c95f89d794a9b.png)  
as well as here

> [@ATC Fork Logic explained](https://forum.pwncnc.com/t/atc-fork-logic-explained/730):
>
> ([Linear Tool Changer (Type 2)](https://docs.masso.com.au/wiring-and-setup/tool-changers/mill-tool-changers/linear-tool-changer-type-2)) It would make the most sense to have racks setup either in the rear along X or on the right along “B/Y2” The reason being you can setup your soft limit to exclude that as travelable area, but it would still go there for tool changes. I have not tested this with the tool setter, but I am prepared to do it, as I have my tool setter setup on the right side, but I also home right, so I don’t know what’ll happen. Thats for this weekend to find out. The following is my…

---

_[View the full topic](https://forum.pwncnc.com/t/movable-tool-slide/989)._