# Break-in / Warm Up Gcode and Chiller Alarm

**URL:** <https://forum.pwncnc.com/t/break-in-warm-up-gcode-and-chiller-alarm/2262>\
**Category:** PwnCNC Spindle System\
**Created:** [November 1, 2024, 11:02pm UTC](https://forum.pwncnc.com/t/break-in-warm-up-gcode-and-chiller-alarm/2262 "2024-11-01T23:02:35Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Cecil](https://yyz1.discourse-cdn.com/flex011/user_avatar/forum.pwncnc.com/cecil/32/44_2.png) [@Cecil](https://forum.pwncnc.com/u/Cecil)\
**Post date:** [November 1, 2024, 11:02pm UTC](https://forum.pwncnc.com/t/break-in-warm-up-gcode-and-chiller-alarm/2262/1 "2024-11-01T23:02:35Z")

</div>

I have been using the Warm Up gcode supplied by PwnCNC. However, now I have added a chiller with a chiller alarm. The suggested use is to run the Warm Up gcode with the coolant supply OFF. However, if I turn the chiller OFF, the chiller alarm stops the gcode and spindle.

I don’t see anyway to solve other than turning the chiller alarm off in the F1 panel. That is a major PITA to try and remember.

Should I just run the Warm UP gcode with chiller on? Other suggestions?

Cecil

---

<div class="post-metadata">

**Author:** ![Chris](https://yyz1.discourse-cdn.com/flex011/user_avatar/forum.pwncnc.com/chris/32/54_2.png) [@Chris](https://forum.pwncnc.com/u/Chris)\
**Post date:** [November 2, 2024, 1:56am UTC](https://forum.pwncnc.com/t/break-in-warm-up-gcode-and-chiller-alarm/2262/2 "2024-11-02T01:56:41Z")

</div>

I don’t run the gcode, i to it manually.  
Having the chiller flowing isn’t a bad thing, might take a few min longer, but it’ll work as well.