# Adding a power Distribution Board

**URL:** <https://forum.pwncnc.com/t/adding-a-power-distribution-board/2468>\
**Category:** General\
**Created:** [December 16, 2024, 1:02am UTC](https://forum.pwncnc.com/t/adding-a-power-distribution-board/2468 "2024-12-16T01:02:23Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![donamlaw](https://avatars.discourse-cdn.com/v4/letter/d/d9b06d/32.png) [@donamlaw](https://forum.pwncnc.com/u/donamlaw)\
**Post date:** [December 16, 2024, 1:02am UTC](https://forum.pwncnc.com/t/adding-a-power-distribution-board/2468/1 "2024-12-16T01:02:23Z")

</div>

I would like to add a Power Distribution Board to my Masso. Do I need to add a fuse in the connection?

---

<div class="post-metadata">

**Author:** ![Loopback77](https://yyz1.discourse-cdn.com/flex011/user_avatar/forum.pwncnc.com/loopback77/32/354_2.png) [@Loopback77](https://forum.pwncnc.com/u/Loopback77)\
**Post date:** [January 4, 2025, 4:52pm UTC](https://forum.pwncnc.com/t/adding-a-power-distribution-board/2468/2 "2025-01-04T16:52:08Z")

</div>

I didn’t add one. I just went from the 24v power (top right terminals on the Masso controller) straight to the power block. Then I tied in to an open ground. I’ve been running it that way for over a year with no issues.